

Page 1 of 2

Text on page 2
INSTRUCTIONS FOR:
ARTEMIS Safety straight edge
Models: 4000,01,02,03,04,05
Thank you for purchasing a SSM product. Manufactured to a high standard this product will, if used according to these instructions and properly maintained, give you years of trouble free performance
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT WAS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE OR PERSONAL INJURY, AND WILL INVALIDATE THE WARRANTY.
PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.
CONTENTS
After unpacking the ARTEMIS Safety straight edge, check to make sure that there is no damage.
OPERATION
2.1 It is important that the ARTEMIS Safety straight edge is used on a flat surface. A warped or bowed table top can induce a twist in the rail resulting in a curved cut or line. Always use a cutting mat or other sacrificial material when cutting. 2.2 The ARTEMIS Safety straight edge can be used with a wide range of tools. (See below)
GENERAL MAINTENANCE
3.1 Regularly clean the ARTEMIS Safety straight edge using a dry cloth, stubborn stains can be removed with a cloth dampened with a little water/detergent. 3.2 SPARE PARTS 4.1 Spare parts can be obtained by calling 763-755-1600.
MyBinding.com 5500 NE Moore Court Hillsboro, OR 97124 Toll Free: 1-800-944-4573 Local: 503-640-5920
Page 2 of 2 · End of manual
