Stanley Bostitch Heavy Duty 3 Hole Paper Punch - BOS03200 Manual, page 1

Page 1 of 3

Stanley Bostitch Heavy Duty 3 Hole Paper Punch - BOS03200 Manual, page 2

Page 2 of 3

Stanley Bostitch Heavy Duty 3 Hole Paper Punch - BOS03200 Manual, page 3

Page 3 of 3 · End of manual

Quick start

  1. Read the safety notes: The hollow punch heads are very sharp. Keep your fingers away from them at all times.
  2. Stand and use both hands: For best results, punch from a standing position with both hands on the handle.
  3. Pick the hole pattern: For standard three-hole punching, place the center hollow punch head over punch disk 3.
  4. Or set two holes: For standard two-hole punching, place the center hollow punch head over punch disk 2 or 4.
  5. Punch the stack: Push firmly and evenly so the punch heads cut through the bottom sheets. The punch is made for up to 160 sheets.
  6. Finish: Bring the handle back to the full upright position before you take out the punched papers.

Troubleshooting

ProblemLikely causeFix (from the manual)
Bottom sheets are not punched throughThe handle was not pushed firmly or evenly.Use two hands and push firmly and evenly so the hollow punch heads go through the bottom sheets. Page 2
Punched papers catch when you pull them outThe handle was not fully upright.Return the handle to the full upright position before removing the papers. Page 2
Punch head is wornHollow punch heads wear with use.Remove the black Phillips screw, set the new head in the black insertion tool from kit 03203, lift it into the punch support as far as it goes, and tighten the screw. Be careful, the old head may still be sharp. Page 3
Holes are not punching evenly and plastic discs wear fastThe plastic discs have not been rotated.Rotate the discs regularly. Push a ball point pen into the groove in the top of the disc to turn it. Page 3
Plastic disc needs replacingThe disc is worn out.Turn the punch over, push the old disc out with a ball point pen with the point retracted, turn the punch upright, and insert the new disc. Page 3
Wrong hole position for two-hole paperThe center head is lined up for three holes.Position the hollow punch head over punch head location 2 or 4. Page 3

Frequently asked questions

How many sheets can the BOS03200 punch?

It is designed to punch 160 sheets of paper cleanly and easily. See page 2.

How do I punch two holes instead of three?

Put the center hollow punch head over punch disk 2 or 4. For three holes, use disk 3. See page 2.

What is the replacement part number for punch heads and discs?

Replacement hollow punch heads and plastic discs are sold as Bostitch model number 03203. See page 2.

How do I replace a plastic punch disc?

Turn the punch over, push the disc out with a ball point pen with the point retracted, then turn it upright and press in the new disc. See page 3.

Is the punch safe to handle?

The hollow punch heads are very sharp, so keep fingers away from them. Use two hands on the handle. See page 2.