Tamerica 210EPB Electric Plastic Comb Binding Machine Manual, page 1

Page 1 of 2

Tamerica 210EPB Electric Plastic Comb Binding Machine Manual, page 2

Page 2 of 2 · End of manual

Quick start

  1. Fit the lever: Slide the handle in from the right side and seat it on the master shaft. Thread in the knob set and tighten it down.
  2. Gauge your stack: Measure how thick the sheets are. The binding gauge and diameter guide gives you the punching depth and the right comb size.
  3. Line up the edge: Move the side guide into position. If the document edge only partly covers a white rectangle on the alignment scale, pull that set pin out. Then dial the binding depth knob to 1, 2, 3 or 4.
  4. Punch the sheets: Feed paper into the punch throat, press the button to punch, and take the paper out. Do this until every sheet has holes.
  5. Seat the comb: Lay the comb between the metal fingers with its opening facing up. Push the master arm backward until the comb opens to the size you need, and hold it there.
  6. Close and lift off: Stand the punched pages up so each finger goes through a hole, then lay them flat. Repeat until all pages are on. Bring the handle upright to close the comb and take the book off the metal fingers.

Troubleshooting

ProblemLikely causeFix (from the manual)
Punched holes fall at the page edgeThe page edge only partly covers a white rectangle on the alignment scalePull the set pin out to cancel that die. Page 2
Comb is the wrong size for the bookPage thickness was not measuredMeasure the stack and pick the depth and comb diameter from the binding gauge. Page 2
Comb fingers do not enter the holesPages are not lined up with the fingersInsert the pages vertically and check that all fingers line up with the punched holes. Page 2
Comb does not open wide enoughMaster arm was not pushed back far enoughPush the master arm backward until the opening is right, and hold it. Page 2
Finished book is stuck on the metal fingersHandle has not been returnedReturn the handle to upright, then lift the book off the fingers. Page 2

Frequently asked questions

How do I choose the right plastic comb size?

Measure the thickness of the pages with the binding gauge. It gives the punching depth and the comb diameter to use. See page 2.

What does the depth knob do?

It sets the binding depth. Turn it to 1, 2, 3 or 4 based on the gauge reading. See page 2.

What if my paper edge covers only part of a white rectangle?

Pull out the set pin over that rectangle to cancel that die. See page 2.

How do I put on the handle?

Insert the handle from the right side onto the master shaft, then insert the knob set and tighten it. See page 2.

How do I close the comb after loading pages?

Return the handle to the upright position, then remove the bound book from the metal fingers. See page 2.