Tamerica 213PB Plastic Comb 3-Hole Punch Binding Machine User Manual, page 1

Page 1 of 4

Tamerica 213PB Plastic Comb 3-Hole Punch Binding Machine User Manual, page 2

Page 2 of 4

Tamerica 213PB Plastic Comb 3-Hole Punch Binding Machine User Manual, page 3

Page 3 of 4

Tamerica 213PB Plastic Comb 3-Hole Punch Binding Machine User Manual, page 4

Page 4 of 4 · End of manual

Quick start

  1. Handle first: Place the handle on the master shaft and tighten the screw.
  2. Check page thickness: Measure the pages to be bound. The binding gauge gives the punching depth and the right comb diameter.
  3. Side guide and depth: Move the side guide and set the binding depth knob to 1, 2, 3 or 4. Pull out the pin to cancel a die when the document edge partly covers a white rectangle on the alignment scale.
  4. Punching: Slide a sheet into the punch throat and pull the handle down. Raise the handle upright, take the paper out, and go on until all pages have holes.
  5. Comb in place: Set the comb behind the metal fingers with the opening side up. Push the handle toward the rear to open the rings.
  6. Finish the book: Insert the pages vertically so the fingers match the punched holes, then lay them down. Return the handle upright and take the book off the metal fingers.

Troubleshooting

ProblemLikely causeFix (from the manual)
Holes run off the page edgeThe page edge partly covers a white rectangle on the alignment scalePull the pin out to cancel that die. Page 2
Wrong comb sizePage thickness was not measuredUse the binding gauge to pick the depth and comb diameter. Page 2
Comb rings do not openHandle has not been pushed backPush the handle to the rear to open the rings. Page 3
Comb fingers do not match the holesPages are not lined upInsert the pages vertically and check that fingers line up with the holes. Page 3
Wire binding will not closeWire diameter is not set on the closerSet the pin at the bottom right of the machine to the wire diameter, place the punched pages with the wire under the press bar, and pull the handle down. Page 4

Frequently asked questions

Can the 213PB close wire binding?

Yes. It has a wire closer. Set the diameter with the pin on the lower right side, put the pages and wire under the press bar and pull the handle down. See page 4.

How do I choose the comb size?

Measure the page thickness and use the binding gauge for the depth and comb diameter. See page 2.

How do I open the comb rings?

Push the handle toward the rear to open the rings. See page 3.

What do the depth knob settings mean?

Set it to 1, 2, 3 or 4 for the binding depth the gauge shows. See page 2.

Does it have a hole punch for loose sheets?

Yes. The manual lists a separate hole punch function. Insert the document into the slot on the back of the machine, line up the sheets and pull the handle down. See page 4.