Tamerica DuraBind 242 14" Legal Plastic Comb Binding Machine Manual, page 1

Page 1 of 2

Tamerica DuraBind 242 14" Legal Plastic Comb Binding Machine Manual, page 2

Page 2 of 2 · End of manual

Quick start

  1. Install the handles: Fit the main handle from the right side onto the master shaft and tighten. Fit the sub-handle from the left side onto the sub-shaft.
  2. Measure: Check the page thickness with the binding gauge to find the punching depth and comb diameter.
  3. Adjust: Move the side guide and set the depth knob to 1, 2, 3 or 4. Pull out a pin if a page edge partly covers a white rectangle.
  4. Punch: Put paper into the punch throat, pull the handle down, return it upright and pull the paper out. Repeat for all pages.
  5. Set the comb: Place the comb opening up behind the metal fingers. Turn the binder stop forward, push the sub-handle forward to the proper opening, hold it, then turn the stop back until it locks.
  6. Bind: Insert pages vertically with the fingers lined up to the holes and lay them down. Return the sub-handle upright and remove the book.

Troubleshooting

ProblemLikely causeFix (from the manual)
Comb fingers do not meet the holesPages were not fed in straightInsert the pages vertically and check that every finger sits in line with a punched hole before you lay them down. Page 2
Binding opening is not the size you needBinder stop and sub-handle were not used in orderTurn the binder stop on the left forward to the end. Push the sub-handle forward to the opening you need and hold it. Then turn the stop back until it locks. Page 2
Comb does not suit the bookThe stack thickness was not measuredMeasure the pages and read the punching depth and comb diameter from the binding gauge. Page 2
Alignment scale shows a partly covered white rectangleThe edge of the document covers part of one white rectanglePull the set pin out to cancel that die. Page 2

Frequently asked questions

How do I attach the handles on the DuraBind 242?

Install the main handle from the right side onto the master shaft. Then install the sub-handle from the left side onto the sub-shaft. See page 2.

How do I pick the comb diameter?

Measure the page thickness and read the comb size from the binding gauge. See page 2.

What is the binder stop for?

Turn it forward before opening the comb, then turn it back until it locks to hold the opening. See page 2.

How do I remove the finished book?

Return the sub-handle upright and remove the book from the metal fingers. See page 2.