Tamerica OfficePro-46E User Manual, page 1

Page 1 of 5

Tamerica OfficePro-46E User Manual, page 2

Page 2 of 5

Tamerica OfficePro-46E User Manual, page 3

Page 3 of 5

Tamerica OfficePro-46E User Manual, page 4

Page 4 of 5

Tamerica OfficePro-46E User Manual, page 5

Page 5 of 5 · End of manual

Quick start

  1. Set up: Place the machine on a sturdy surface and plug it into a wall outlet.
  2. Check depth: Use the table to pick the coil diameter and set the depth margin control dial for your sheet count.
  3. Prepare the feed tray: Open the feed tray cover, put your document on the feeder, and adjust the side margin guides.
  4. Disengage pins: Disengage pins that would punch off the edge of the page. Press the punch switch to punch.
  5. Insert coil: Plug in the foot pedal. Line up the punched pages, insert the coil by hand into the first holes, and press it against the roller with the roller toggle switch OFF.
  6. Finish: Press the foot pedal to feed the coil through the rest of the holes. Crimp the ends with the coil crimper pliers.

Troubleshooting

ProblemLikely causeFix (from the manual)
Machine takes damage while punchingThe waste drawer is too fullLook in the waste drawer from time to time and empty it. Page 5
Coil inserting roller wears out sooner than it shouldThe roller toggle switch was left ON, or the roller was left runningKeep the toggle switch OFF and press the foot pedal to insert the coil. Page 4
Document comes unboundThe coil ends were not crimpedCrimp both ends with the handheld coil crimper pliers. Page 4
Holes run off the sides of the sheetsPins that fall outside the paper are still engagedPunch a test sheet to check, then disengage the pins that would punch off the edge. Page 5
Machine wears faster on big punching jobsToo many sheets went through in one passNever punch more than 20 sheets of 20 lb paper. 12 to 15 sheets at a time is better. Page 5
Hard to punch PVC or PP coversCover material was punched in a large stackPunch 2 sheets at most at a time. Page 5
Machine malfunction or technical issueA fault in the machineCall the authorized dealer first. Fixing it yourself can be dangerous and may void the warranty. Page 5

Frequently asked questions

How many sheets can the OfficePro-46E punch?

Do not punch more than 20 sheets of 20 lb. paper. The manual suggests 12 to 15 sheets at a time. See page 5.

How do I insert the coil?

Insert the coil by hand into the first holes, press it to the roller, then use the foot pedal for the rest. See page 4.

Should I leave the roller switch on?

No. Keep it OFF and use the foot pedal, since leaving it ON causes early roller wear. See page 4.

What if holes would fall off the edge?

Disengage the pins that would punch off the page. A test sheet helps check this. See page 5.

How long is the warranty?

Machines are guaranteed against defects for one year from purchase from an authorized dealer. See page 5.