

Page 1 of 5

Page 2 of 5

Page 3 of 5

Page 4 of 5

Page 5 of 5 · End of manual
Quick start
- Practice first: Use blank or scrap paper before the real job to learn the steps.
- Install the master arm: Turn the master arm left to the position marked on the Binder Stop plate to see the screw hole on the arbor. Line the arm's screw hole up with the arbor and fasten the enclosed screw tight with the L wrench.
- Pick the comb: The coil must be 2mm to 3mm (1/16 to 1/8 in) larger than the paper stack including covers. Match the comb size to the number of holes.
- Place the comb: Put it open side up behind the binding fingers and let it fall forward so the hooks engage the rings.
- Open the comb: Turn the Binder Stop Knob down, push the Master Arm backward until the opening is right, hold it, then turn the knob back until it locks.
- Bind: Hold the pages flush and face down with the front cover on the bottom. Work the pages until all comb tips go through the holes.
- Release: Push the arm back to close the comb and pull it as far as it relaxes so the hooks disengage. Take out the book.
Troubleshooting
| Problem | Likely cause | Fix (from the manual) |
|---|---|---|
| Pages do not lie flat, are hard to turn, or tear out | The comb diameter is too small | Use a comb 2mm to 3mm (1/16 to 1/8 in) larger than the paper stack including covers. Page 3 |
| Comb tips do not go through the holes easily | Pages are not flush or not seated on the tips | Hold the pages together tightly with edges flush and move them gently back and forth. Page 3 |
| Comb stays hooked after binding | The arm was not pulled all the way | Pull the arm as far as it relaxes so the hooks fully disengage the comb. Page 3 |
| Comb opening ends up at the front of the book | Pages were entered the wrong way up | Enter the pages face down with the front cover on the bottom so the opening is at the back. Page 3 |
| Master arm will not attach to the arbor | The screw holes are not lined up | Follow the install steps, line up the screw holes and fasten the screw with the L wrench. Page 2 |
Frequently asked questions
How much larger should the comb be than my stack?
The coil diameter must be 2mm to 3mm (1/16 to 1/8 in) larger than the paper thickness, covers included. See page 3.
How many sheets fit a 1-1/8 in comb?
The chart lists 250 sheets for a 1-1/8 in (28mm) comb, at depth guide position 4. See page 4.
What depth position is used for a 1/2 in comb?
A 1/2 in (12mm) comb holds 112 sheets and uses depth guide position 2. See page 4.
Which way do I load pages onto the comb?
Face down with the front cover on the bottom. This puts the comb opening at the back of the book. See page 3.
How do I install the master arm?
Line up the arm's screw hole with the arbor and fasten the enclosed screw tight with the L wrench. See page 2.
