

Page 1 of 2

Page 2 of 2 · End of manual
Quick start
- Install the master arm: Turn the master arm on the left side to position 1 on the Binder Stop Plate. Set the binder stop pin to position 2, then secure the arm with the enclosed screw and an allen wrench.
- Pick a comb: Choose a comb 2mm to 3mm (1/16 to 1/8 inch) larger than the thickness of the sheets, covers included. The ring count should match the punched holes.
- Set the opening: Pull the Binder Stop Knob and set the pin. Pull the Master Arm forward to the opening you need and hold it. Turn the knob back until it locks on the plate.
- Place the comb: Put the comb behind the binding fingers with the open side up. Let it fall forward between the fingers so the hooks catch the rings.
- Load the sheets: Hold the punched sheets flush and face down, with the front cover on the bottom. Feed the comb tips through all the holes.
- Close the comb: Push the arm all the way back. This closes the comb and releases the bound book.
Troubleshooting
| Problem | Likely cause | Fix (from the manual) |
|---|---|---|
| Pages will not lie flat or are hard to turn | The comb diameter is too small for the stack. | Use a comb 2mm to 3mm larger than the sheet thickness, including covers. Page 2 |
| Comb tips will not go through the holes | Sheets are not fully lined up with the comb tips. | Hold the edges flush and move the sheets gently back and forth while feeding the tips through. Page 2 |
| Bound book does not release | The arm was not pushed fully back. | Push the arm all the way back so the hooks release the comb. Page 2 |
| Book looks untidy or the comb opening faces the wrong way | Sheets were laid on the comb the wrong way up. | Lay the sheets face down with the front cover on the bottom, so the comb opening ends up at the back. Page 2 |
| Comb rings do not match the holes | The comb has a different ring count than the punched holes. | Use a comb whose ring count matches the holes punched in the sheets. Page 2 |
Frequently asked questions
What comb size should I use?
The comb diameter should be 2mm to 3mm (1/16 to 1/8 inch) larger than the stack, covers included. A binding gauge guide is printed in the manual. See page 2.
Why won't my pages turn easily?
The comb is likely too small. A comb that is too small keeps pages from lying flat. See page 2.
How do I install the master arm?
Set the arm to position 1 and the binder stop pin to position 2. Then fix the arm with the enclosed screw using an allen wrench. See page 2.
Which way do I put the comb in?
Place the comb behind the binding fingers with the open side up. Let it fall forward so the hooks engage the rings. See page 2.
How do I get the finished book off the machine?
Push the arm fully back to close the comb. The hooks then release the book. See page 2.
