

Page 1 of 2

Page 2 of 2 · End of manual
Quick start
- Attach the handle: Insert the handle from the right side onto the master shaft. Then insert the knob set and tighten it.
- Choose a comb: Measure the paper thickness and use the binding gauge to pick the comb diameter and punching depth.
- Set the guides: Adjust the side guide. Set the binding depth knob to 1, 2, 3 or 4.
- Punch: Insert paper into the punch throat. Pull the handle down, return it upright, and pull the paper out. Repeat for all sheets.
- Load the comb: Place the comb with the opening side up behind the metal fingers. Use the Binder Stop and Master Arm to open it.
- Bind: Fit the punched papers on the fingers, lay them down, then return the handle upright and remove the book.
Troubleshooting
| Problem | Likely cause | Fix (from the manual) |
|---|---|---|
| Part of a hole is covered on the alignment scale | The document edge covers part of a white rectangle. | Pull the set pin out to cancel that die. Page 2 |
| Paper not positioned correctly for punching | Side guide is off. | Adjust the side guide. Page 2 |
| Hole depth does not suit the stack | Depth knob not matched to the thickness. | Measure the stack and set the knob to 1, 2, 3 or 4 using the binding gauge. Page 2 |
| Comb will not open to the right size | Binder Stop not set. | Push the Master Arm forward to the proper opening, hold it, and turn the Binder Stop back until it locks. Page 2 |
Frequently asked questions
How do I choose a comb size?
Measure the paper thickness and use the binding gauge and diameter guide in the manual. See page 2.
How do I set the punching depth?
Turn the depth knob to 1, 2, 3 or 4 based on the stack thickness. See page 2.
What does the set pin do?
Pulling it out cancels a die when a document edge partly covers a white rectangle on the alignment scale. See page 2.
Which way does the comb go on the machine?
Place it with the opening side up behind the metal fingers. See page 2.
