

Page 1 of 6

Page 2 of 6

Page 3 of 6

Page 4 of 6

Page 5 of 6

Page 6 of 6 · End of manual
Quick start
- Place it: Set the laminator on a flat surface with space behind it for the laminate to feed out.
- Load the film: Slide the roll film onto the upper and lower rods, with equal rod length showing at each end. Load the rods in the machine. It takes 1 inch core film up to 690mm (27 inch) wide.
- Thread the film: Pull the handle forward to release roller pressure. Push the film through the rollers, perfectly aligned top and bottom, then replace the feed tray.
- Set heat: Turn on the power switch and set the temperature to 90 C (194 F) to start. Press HOT and the heater light glows.
- Set speed: Use the MOTOR keys. The table gives settings by film thickness, such as 125 C and speed 3 for 5 Mil film.
- Balance the tension: Top and bottom supply rolls should have similar tension. Turn the knob clockwise to increase it.
- Shut down: Press COOL. Keep the motor running until the rolls are cool, then turn the machine off.
Troubleshooting
| Problem | Likely cause | Fix (from the manual) |
|---|---|---|
| ER1 on the screen | The internal thermometer is damaged. | The machine switches itself off to protect itself. Service is needed. Page 4 |
| ER2 on the screen | The machine kept heating for over 12 minutes. | It switches itself off automatically. Page 4 |
| ER3 on the screen with a buzzer | Machine temperature is higher than 200 C (392 F). | It switches itself off automatically. Page 5 |
| Laminated product curls | Top and bottom film tension is unequal. | If it curls up, the top roll is probably tighter. If it curls down, the bottom roll is. Turn the adjusting knob to balance them. Page 4 |
| Document jams or is about to jam | Material stuck in the rollers. | Press REVERSE to pull the document out. Page 4 |
| Film leaves residue on the rolls | Film overlap when threading. | Rethread so the film is perfectly aligned top and bottom. Page 2 |
Frequently asked questions
How do I stop a jam from ruining a document?
Press the REVERSE key to pull the document back out. See page 4.
What do the ER1, ER2 and ER3 messages mean?
ER1 means a damaged thermometer, ER2 means heating for more than 12 minutes, and ER3 means the temperature went above 200 C (392 F). See page 4.
Why does my laminate curl?
The top and bottom film tension is uneven. Adjust the tension knob until both rolls feel the same. See page 4.
What roll size does it take?
It uses film on a 1 inch core, up to 690mm (27 inches) wide. See page 4.
Can I switch between C and F?
Yes. Press the temperature set down key first, then press the up key at the same time. See page 5.
