The GrandStand Single -Sided Retractable Banner Stand Installation Instruction, page 1
Text on page 1

The GrandStand

  1. Get the hex key from underneath the base.
  2. Remove the hex screws on both sides with the hex key.
  3. Open the lid and remove the graphic roller.
  4. Pull out the panel strip from the graphic roller.
  5. Remove the liner on the front tape and press the graphic on the panel strip. Do the same to the top panel strip (squarely).
  6. Insert the bottom panel strip back into the graphic roller.
  7. Insert the top panel strip into the top profile. With a piece of clear tape on the back, center and secure the graphic to keep it from sliding.
  8. Put the graphic roller back into the base and secure the lid on both sides with the hex key.
  9. Pull out the locking key and roll the graphic slowly into the base. Gently hold on to the graphic to keep it from retracting too quickly.
  10. Insert the pole into the base.
  11. Pull out the graphic from the base and keep one foot on the base to prevent it from pulling up.
  12. Insert the top into the top profile. Installation is now complete.

USA Drytac Corporation customerservice@drytac.com 1.800.280.6013

CANADA

Drytac Canada toronto@drytac.com 1.800.353.2883

Rev Apr 2014

Graphic Installation Instructions

Page 1 of 1 · End of manual

Quick start

  1. Take the hex key from underneath the base and remove the hex screws on both sides.
  2. Open the lid, remove the graphic roller and pull out its panel strip.
  3. Remove the liner from the front tape and press the graphic squarely onto the bottom panel strip, then do the same with the top panel strip.
  4. Insert the bottom panel strip back into the roller and the top strip into the top profile. Center and secure the graphic with clear tape on the back.
  5. Put the roller back in the base and secure the lid on both sides with the hex key.
  6. Pull out the locking key and slowly roll the graphic into the base, holding it so it does not retract too quickly.
  7. Insert the pole into the base, pull the graphic up while keeping one foot on the base, and fit the top profile onto the pole.

Frequently asked questions

Where is the hex key for The GrandStand?

It is stored underneath the base (page 1).

How do I keep the graphic from sliding in the top profile?

Center it and secure it with a piece of clear tape on the back (page 1).

How do I stop the graphic from snapping back into the base?

After pulling the locking key, gently hold the graphic as it rolls in, and keep one foot on the base when pulling it out (page 1).