We're sorry, but we no longer offer this item.
Call us at 1-800-944-4573 for personalized recommendations
check out these similar items that may be a good fit
Product Description
This starter kit is everything you need to start mounting and laminating. It comes complete with the (1) 25" Polar Cub Laminator, (1)ImageEdge Foam Board Cutter, 24" x 36" Adhesive Foam Boards (10pk), 24" x 36" Gloss Pouch Boards (10pk), and 20" x 30" Laminating Sheets (10pk). Get yours now and enjoy huge savings!This 25" manual mounting and laminating machine is hand-crank operated, and is compatible with a wide selection of mounting boards, including self-stick mounting boards, pouch boards that have a pre-applied pressure sensitive adhesive, self-stick mat boards, and plain mounting boards paired with pressure sensitive mounting adhesive. This easy-to-use cold laminator is ideal in creating a professionally mounted print in just a few minutes.
Product Details
- Starter Kit Includes:
- 25" Polar Cub Laminator
- Image Edge 48" Foam Board Cutter
- 24" x 36" Adhesive Foam Board (10 sheets)
- 24" x 36" Gloss Pouch Boards (10 sheets)
- 20" x 30" Gloss Film Sheets and sled (10 sheets)
- Actual Machine Dimensions: 28" x 24" x 11"
- Actual Machine Weight: 29
- Shipping Length: 33
- Shipping Width: 9
- Shipping Height: 14
- Shipping (Web) Weight: 52
- 25" Polar Cub Laminator Features:
- Can mount boards up to 1" thick.
- Uses all types of self stick adhesive coated mounting boards.
- Rugged design and ready to use out of the box.
- Great for mounting larger prints.
- Professional grade silicon rollers provide even pressure and insure bubble free results and any exposed adhesive on the board will not stick to the rollers.
- Easy to Use:
- To set the gap between the rollers to match the thickness of your board, place your board between the rollers and close the rollers by turning the height control knob until there is no light between the board and the rollers. Then tighten the rolls a half turn on the height control knob. If you are using the same boards all the time, this will only need to be done once.
- Peel back the first inch of the release liner. Smoothly tack down your print to the inch of exposed adhesive. Insert the tacked edge into the laminator, remove the remainder of the release liner. Hold your print up so that it is smooth against the rollers.
- Turn the handle to pull your print and board through the laminator. Your print will be mounted, trim your print if desired.
Subscribe to Get Exclusive Offers!
Receive a 10% off coupon for just signing up.
Partners
Copyright © 2026 MyBinding
