Royal Sovereign RSC-1401CLTW 55" Cold Roll Laminator

In this segment we're going to show you how to web a Royal Sovereign cold 55” or 65” Laminator. First what we need to do is to get a roll of lamination film, you'll see on your lamination film that you have a release liner on one side of your film and you laminate on the other. The way you put the laminate on to your laminator on the supply you want your adhesive that's on your laminate to come down on the backside we do release liner to the front. This way, when the film comes over the rollers your adhesive will not be touching the rollers. We need to remove the supply shaft off the back of the laminator by lifting off to one side and pulling it out from the other side. What we have are two water grips that are on the shaft that we want to make sure will be positioned inside the core of the roll of lamination film. We insert the supply shaft into the core of the film and slide it all the way through to the other side. Next, we go back to the back little laminator, take our supply shaft, we'll get into the one side and drop the other side down into the slot. Now we come to the front of the laminator, what we're going to do is open up the gap on the rollers so that we have maximum gap on the top roller, from there we'll take a sacrificial piece of material and place it in between the nip of the two rollers. Next, we'll take our film bring it underneath the idler bar and into the nip of the rollers. We want to make sure our sacrificial piece of material is centered with the roll of laminate. Now, we'll come down and drop these rollers down so they meet each other. The next step we want to make sure is that we're taught all the way across here and we don't have any gapping. You see this side, it's a little bit loose, this slide is a little bit tight. So, we're going to open up our rollers and we're going to adjust this side so it's a little taut and drop it back down. Next, we're going to take a pair of scissors and score the release liner on the backside. We'll take our scissors and separate the release liner from the film. We're going to hit the run button on the laminator until we have enough release liner to tape on to the release liner take up shaft. Then we'll take some film, take and we're going to take a relief liner in three spots to take up. Now we're ready to laminate.

This segment is going to show you how to laminate media on a cold laminator. Now that we have our laminator webbed, we're going to take our material that came off our inkjet printer. We're going to set it on the feed table of the laminator, we're going to take the bottom supply shaft off the laminator and insert it into our media. Now that position is back on the bottom supply. We're going to bring the media up over their feed table and we want to bring our media so that it's centered with a lamination film. Bring the media up, hit the one switch, we'll see the lamination film into the laminator. Once your material comes through the backside of the laminator, we're going to hit the stop button. I'm going to tape this to the back supply core on your rewinder. Hit the run button and continue our lamination process.