Product Description
This SealerSales HWS-802HW Hand Wheel Direct Heat Sealer is a constant heat hand wheel sealer that seal plastic material with a 5mm seal width. Simply place the PTFE coated wheel along the material whether the material is polyethylene or cellophane. This versatile sealer can make round, oval, square or any unique shape with a textured mesh seal. It is great for irregular size packaging and suited for sealing thicker materials. This SealerSales HWS-802HW can be also used for cut and seal applications by angling at a 45 degree angle.
Product Details
- Great for irregular size packaging.
- Suited for sealing thicker materials.
- Equipped with a convenient rack to hold sealer when not in use.
- Temperature can be regulated from 150oF to 360oF with a quick turn of the knob.
- Temperature controller contains on/off switch with safety light.
- Sealing wheel is PTFE coated with an embossed design and makes 1/4" (5mm)
- Safety shield protects user from accidentally touching the hot wheel.
- Protective rubber mat included.
- All metal construction.
- Warm up time required (5-10 minutes).
- Unit can be used for cut and seal applications by angling at a 45 degree angle.
- Easy to Operate:
Place the unit on the rack and plug into an outlet. Turn on the temperature control knob to the setting that seals the material. Allow the unit to heat up for approximately 10 minutes. Place the material to be sealed on the heat resistant rubber mat and roll the hand wheel across the material. Note: A few trials may be necessary to determine the correct temperature setting and speed. - Hints for Best Results:
- Always use the smooth heat resistant rubber mat or corrugated cardboard under the material to be sealed.
- Never seal on glass, paper, or wood.
- Roll the hand wheel slowly and steadily over the material to be sealed.
- Avoid pressing down too hard or rolling too fast.
- Adjust the temperature and/or speed to get the desired seal.
- Replace the hand wheel sealer on the rack when finished sealing.
- Turn off the switch when sealing is completed.
- If you want a "seal & cut" type of seal, turn the unit so that only the wheel edge comes in contact with the plastic material.
- Always remove any bits of accumulated plastic from wheel by using a dry cloth or soft brush.
- Always unplug the unit before performing any maintenance.
Specifications
- Power Supply: 120V, 60Hz
- Watts: 70W
- Seal Length: Unlimited
- Seal Width: 5mm
- Hand Wheel Weight: 13oz
- Stand Weight: 6oz
- Power Cord Length: 6ft
- Rubber Mat: 11 3/4" x 11 3/4" x 1/16"
- Material Thickness: 10mil
- Temperature Range: 150°F-360° (65°C-180°C)
- Weight: 3LBS
Video
HWS-802 HWS-803 Hand Wheel Sealer Demo
Transcript :
You May Also Like
Subscribe to Get Exclusive Offers!
Receive a 10% off coupon for just signing up.
Partners
Copyright © 2026 MyBinding
